Nine, in the running state, keep pressing the main button, the lightsaber will enter the light effect change mode (the light effect mode in 8 cycles in turn), when you reach the light effect mode you need, you only need to release the main button, you can Select the current light effect mode.ġ0. In standby mode, long press the main button, lightsaber will shut down.Įight, in the running state, short press the main button, lightsaber's sword bundle will be retracted, and then lightsaber enters the standby state. Sixth, in the standby state, press and hold the main key and the sub key at the same time, the blade segment displays the color combination currently displayed by the lightsaber.ħ. Repeat the operation of 7 bank sound effects, which can be switched at a time. In standby mode, short press the main button, the lightsaber lights up.įifth, in standby mode, long press the sub key to switch the sound effect bank. (Red indicates that the battery is almost dead, blue indicates that the battery has half the power, and green indicates that the battery has sufficient power)Ĥ. In the off state, long press the sub key, the blade can display the lightsaber's current battery capacity. Second, in the shutdown state, long press the main button and the sub button, the lightsaber enters the silent mode, repeat this operation, you can turn off the silent mode.ģ. The state of the lightsaber is divided into shutdown state, standby state, running state, the trigger time of each button in the three states can be set by the user himself, and different buttons or combinations can achieve different operating functions.įirst, in the shutdown state, long press the main button, the lightsaber enters the standby state, the main button indicator will be always on. This will remove the short circuit protection. At this time, you need to use the 5V power charging cable to plug in the lightsaber's charging interface. Because the initial state of the battery is capacitive, this action may trigger short-circuit protection when the battery is removed and then reinstalled. The control circuit of this lightsaber includes battery anti-reverse protection and short circuit protection circuits. And we suggest that the hilt and blade of the lightsaber should be stored separately. If the lightsaber is not suitable for a long time, please save it after fully charging. Users can set whether the power saving mode is turned on, and the power saving time can also be set by themselves. When the lightsaber is in the non-trigger induction or standby state for a long time, it will automatically close the sword or shut down. When charging, if the blade is fixed on the hilt of the lightsaber, the blade will display according to the battery voltage. You can set one of the charging modes yourself. After lightsabers are charged, the lights will be on.
Second, during charging, the lights on the lightsaber's main button will be displayed according to the current battery power. When charging, the lights of the lightsaber's main button are always on, and the lights will turn off when fully charged. There are 2 types of charging instructions: 1. It is recommended to use the computer USB port for charging. A voltage exceeding 5V will cause permanent damage to the charging chip. The LED Jedi Saber is 39'' total.Please use the 5V1A power supply for charging. Rechargeable Battery with Charging Accessories Included.
The Saber's blade is durable but will not cause any harm.
0 kommentar(er)
